Do not remove the set screw from the beam selection port. Insert Adjustment Tool into the beam selection port and make three counterclockwise turns. To return to the modulated (pulsed) laser mode, simply Reassemble and confirm that your beam is now continuous wave (steady on). Slowly turn the Adjustment Tool clockwise until you feel resistance. Insert Adjustment Tool into the beam selection port. To change to a continuous wave (steady on) beam, follow these simple steps: The Uni-Max comes factory set for a modulated (pulsed) beam for higher visibility. To sight in your laser, insert the Adjustment Tool into one of the small alignment ports on the outside of the Laser Housing.įine tune your laser alignment by slowly turning theĪdjustment Tool, then checking your laser position against your fixed sights and your POI(Point of Impact).
0 Comments
Leave a Reply. |